CRANKSHAFT MOUNTING TOOL KTM 250/300 2T

SPECIAL CRANKSHAFT MOUNTING TOOL KTM.

- FITS KTM 300/250 SX, MXC, EXC, EGS
- Crankshaft mounting tool Specifically designed for KTM crankshaft assembly. .
- Fits crankshaft smoothly without damage to crankshaft or bearings.
- Overall length of tool is 146mm and constructed from carbon steel.
- Fitting face is O.D. 70mm x I.D. 43.5mm / 3.5mm depth.
- Long bolt end is Dia. M12 x 1.25mm with drive hole.
- products are a high quality Tools, Accessories and Part and carries our guarantee of your satisfaction.

Part No. 00-8100

Instructions.
Sometimes the final assembly is done with a cold crankcase and a puller tool. This tool uses a long nut / stud to connect to the crankshaft end and a thick tube that allows you to pull the crankshaft through the main bearing without damage. By only pushing on the inner bearing race no damage to bearings will occur . Assembly is the same only you don't heat the crankcase. You pull the crankshaft through the bearing and this slides the two crankcases together.

Majority of our listings are for a direct replacement for your original part.

Our parts are made of quality and are designed to meet or exceed the original OEM Standards.

Our products are often a cost effective alternative to genuine OEM Parts.

Please note: the models of bike we state in our listings are for general guidance only. Please make sure this item will fit your bike before purchasing. Also, we cannot guarantee fitment to any non-UK models.