FLYWHEEL PULLER M27 x 1.25,MX-12927 HUSKY/KTM 1970-80 2 stroke models

M27x1.25 R/H FLYWHEEL PULLER 27mm

Description:

• Fits Motoplat small internal rotor MX & ENDURO.
• Suitable for HUSQVARNA (FEMSA - BOSCH - MOTOPLAT) Most 1960-1970 2 Stroke Models w/C.D.I. Ignition.
• Compatible with KTM (FEMSA / BOSCH / MOTOPLAT) Most 125cc, 250cc 300cc, 360cc, 495cc XC & MX 2 Stroke Models, and most BULTACO, OSSA, MONTESA, PENTON, SACHS & MAICO [MP3].

Fits most:

• Husqvarna: 1970-80 2 stroke models with CDI ignitions.
• KTM: Current 2 stroke liquid cooled models.
• Classic: Ignition points with condensers or CDI Ignition Systems - Bultaco, Ossa, Montesa, Husqvarna, Penton, Sachs, and Maico.

Tips on use:

• Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
• Use copper grease on the puller threads for long life.
• Ensure the puller is fully screwed into the flywheel.
• After tightening, use a hammer on the center and tap to jolt free (not always needed).
• If using old flywheel pullers, make sure the threads are in good condition before use to avoid damage to the flywheel.

Majority of our listings are for a direct replacement for your original part.

Our parts are made of quality and are designed to meet or exceed the original OEM Standards.

Our products are often a cost effective alternative to genuine OEM Parts.

Please note: the models of bike we state in our listings are for general guidance only. Please make sure this item will fit your bike before purchasing. Also, we cannot guarantee fitment to any non-UK models.