FLYWHEEL PULLER M18 x 1.50 RH

FLYWHEEL PULLER EXTRACTOR 18mm x 1.50mm RightHand.

YAMAHA
MX CROSS YZ125/250,,

• Used for removal of the flywheel or rotor if applicable.
• Premium quality high carbon steel
• Heat treated for strength and durability
• Durable hot black oxide finish

Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel.

Part No. 00-096.DR [FACTORY IMAGE RACING]

Cross reference numbers.
BUZZETTI 5208, UP-12919

Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel.

Majority of our listings are for a direct replacement for your original part.

Our parts are made of quality and are designed to meet or exceed the original OEM Standards.

Our products are often a cost effective alternative to genuine OEM Parts.

Please note: the models of bike we state in our listings are for general guidance only. Please make sure this item will fit your bike before purchasing. Also, we cannot guarantee fitment to any non-UK models.