FLY WHEEL PULLER SET YZF400

Magneto YZ400 4-Stroke Yamaha 1 set of holes.

Flywheel Puller, WR400F/Kawasaki Jet Ski 300/440/550

Puller kit for pulling magneto flywheel or starter gear on Kawasaki Jet Ski 300/440/550 Will also fit the Yamaha WR250F 01-02 and WR400F flywheel and some older Kawasaki 3 bolt flywheels Includes three 6 x 25 mm and three 8 x 40 mm bolts 8 mm bolt hole center is 27 mm to dead center 6 mm bolt hole center is 49.15 mm to dead center.

Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel.

Majority of our listings are for a direct replacement for your original part.

Our parts are made of quality and are designed to meet or exceed the original OEM Standards.

Our products are often a cost effective alternative to genuine OEM Parts.

Please note: the models of bike we state in our listings are for general guidance only. Please make sure this item will fit your bike before purchasing. Also, we cannot guarantee fitment to any non-UK models.