FLY WHEEL PULLER 55mm x 1mm

FLY WHEEL PULLER 55mm x 1mm RH. DUCATI

It fits Ducati 200/250/350 and most narrow-case bevel single models.

HOLDER O.D.: 62MM, Thread I.D.: 55mm, LENGTH: 79MM.
BOLT: 1/2" X 12UNC, LENGTH: 93MM, SIDE TO SIDE: 19MM.

• Hard black oxide finish.
• The only way to remove that flywheel unless you're a hammer-toting, knuckle-dragging mouth-breather
• This professional puller should be in the toolbox of every owner of Ducati singles.
• The new design has a replaceable brass bushing at the contact point, and it should fit all later wide-case machines.

NOTE.
Please check the thread size of your motor before ordering

Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel.

[FACTORY IMAGE RACING]

Cross Reference Numbers Only:
UP-12231-1, 88713-0250

Majority of our listings are for a direct replacement for your original part.

Our parts are made of quality and are designed to meet or exceed the original OEM Standards.

Our products are often a cost effective alternative to genuine OEM Parts.

Please note: the models of bike we state in our listings are for general guidance only. Please make sure this item will fit your bike before purchasing. Also, we cannot guarantee fitment to any non-UK models.